HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
370
Action • Log in as MANAGER.SYS in some other group than INSTALL or
PUB.
• Run the installer again.
217 Message Failed to set file equations for link editor. (INSTERR #217)
Cause An attempt to set a file equation for the link editor help and catalog files
through the HPICICOMMAND intrinsic failed. The FILE Command Table
is possibly full.
Action • Check if any further FILE commands can be entered with the FILE
command.
• RESET any user file equations.
• Take appropriate corrective measures and run HPINSTAL again.
HPINSTAL will reissue any required file equations.
• Contact the Response Center if further assistance is required.
218 Message MESSAGE patchid Too many dependent patches (INSTERR #218)
Cause Invalid data in AUTODEP file.
Action Note the displayed patchid, save the PATCHAUD and INSTERRS files,
and call the Response Center for assistance.
219 Message FREADLABEL failed on filename. (INSTERR #219)
Cause A call to the intrinsic FREADLABEL failed when CUSTOM attempted to
read a file label of either FILEINFO.INSTALL.SYS or
DEPINFO.INSTALL.SYS.
Action • Document any error message text that occurred prior to the error.
• Ensure that the specified file exists in the INSTALL.SYS group.
• If necessary, follow the instructions in your installation manual to
initialize your system by using the SETUP process.
•Run HPINSTAL again.
• Contact the Response Center if further assistance is required.
220 Message Verification of VUF failed on filename file. (INSTERR #220)
Cause The VUF in the file label of the specified file does not match the VUF of
the compact disk as specified in the CI variable mpe_targ_vuf.
Action • Follow the instructions in your installation manual to initialize your
system by using the SETUP process.
•Run HPINSTAL.
• Contact the Response Center if further assistance is required.
221 Message Encountered an error while retrieving the CI variable,
variable name. (INSTERR #221)
Cause Could not retrieve the value of the indicated CI variable.
Action • Use SHOWVAR variable name to check the status of the variable.