HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
368
•Run HPINSTAL again.
• Contact the Response Center if further assistance is required.
206 Message Failed to decrypt filename. (INSTERR #206)
Cause CUSTOM failed to decrypt an encrypted file.
Action • Ensure that HPINSTAL copied the specified file to the local group.
• Purge the file.
•Run HPINSTAL again.
• Contact the Response Center if further assistance is required.
207 Message Error trying to RUN SYSGEN.PUB.SYS. (INSTERR #207)
Could not activate SYSGEN process, PIN = pin number
Cause ACTIVATE failed on the newly created SYSGEN process.
Action Save all messages on the screen and check the messages in the bottom of
AUTOLOG. Call the Response Center for further assistance.
208 Message Could not arm handler for switching the CD-ROM volumes.
(INSTERR #208) PEARM Error: info = number, subsys = number
Cause The call to PEARM returned a nonzero status. Record the listed status
values before contacting the Response Center.
Action • Ensure HPCDXL.INSTALL.SYS exists and has no file equations set
on it.
• Ensure NL.PUB.SYS exists and has no file equations set on it.
• Take appropriate corrective actions and restart HPINSTAL.
209 Message Failed to initialize the CD-ROM volume names through
the INITCIVR command file (INSTERR #209)
Cause An attempt to set the HPINSTAL environment variables though the
command script, INITCIVR.INSTALL.SYS, failed.
Action • Check the CI error message preceding the INSTERR #209 message
and take appropriate corrective action.
• If INITCIVR.INSTALL.SYS does not exist, VSCLOSE both CD-ROM
volumes and follow the setup procedures in the HPINSTAL manual.
210 Message HPVOLINFO error while attempting to access volume name
. (INSTERR #210)
Cause A call to HPVOLINFO to determine whether the second CD-ROM volume
is mounted has failed with an unexpected error status.
Action • Check the state of the CD-ROM volumes with the DSTAT command.
• Ensure that all mounted CD-ROMs are listed as ONLINE and
MASTER state.
• Ensure that the listed CD-ROM volumes are physically mounted on
the system.
• If there is only one CD-ROM drive, ensure that the original CD-ROM
volume has been VSCLOSED and is offline before inserting another
volume.