HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
367
during Phase 1. HPINSTAL makes this determination by comparing the
version of your current MPE/iX release with the version of the release on
the combined CSLT/STORE tape.
Action • Halt the system and perform an UPDATE with the CSLT/STORE tape
created during Phase 1 of HPINSTAL.
• Start the system.
• Once the system is up, log on to the system as
MANAGER.SYS,INSTALL, start the spooler, and enable the streams
device.
•Run HPINSTAL again.
• Contact the Response Center if further assistance is required.
203 Message The file TARGVUF.PUB.SYS is missing. (INSTERR #203)
Cause This file is installed on a system as a result of performing an UPDATE
with the CSLT/STORE tape created during Phase 1 of HPINSTAL.
HPINSTAL looks for this file prior to completing the update with FOS,
STORE, and SUBSYS components, to ensure the operating system has
been UPDATEd to the appropriate level.
Action • Halt the system and perform an UPDATE with the CSLT/STORE tape
created during Phase 1 of HPINSTAL.
• Start the system.
• Once the system is up, log on to the system as
MANAGER.SYS,INSTALL, start t he spooler, and enable the streams
device.
•Run HPINSTAL again.
• Contact the Response Center if further assistance is required.
204 Message Error while attempting to compare your system's build
id with that of the release on the CSLT. (INSTERR #204)
Cause HPINSTAL is unable to successfully compare the release v.uu.ff of your
system with the release v.uu.ff for which this CSLT/STORE tape was
created.
Action • Halt the system an perform an UPDATE with the CSLT/STORE tape
created during Phase 1 of HPINSTAL.
• Start the system.
• Once the system is up, log on to the system as
MANAGER.SYS,INSTALL, start t he spooler, and enable the streams
device.
•Run HPINSTAL again.
• Contact the Response Center if further assistance is required.
205 Message Failed to copy filename to the local group. (INSTERR #205)
Cause HPCICOMMAND intrinsic failed on the COPY command.
Action • Document any error message text that occurred prior to the error.
• If the target file exists, purge it.