HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
363
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
183 Message Error in applying Z02Z216A - AS/DS changes in SYSGEN.
(INSTERR #183)
Cause The installer invoked SYSGEN.PUB.SYS to add or delete a number of
system files as described in the file Z02Z216A.INSTALL.SYS. SYSGEN
encountered an error processing the file Z02Z216A.INSTALL.SYS and the
installer trapped on the error condition.
Action • Print file AUTOLOG.INSTALL.SYS to view detailed error from
SYSGEN.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
184 Message Error in making IDP file change in SYSGEN. (INSTERR #184)
Cause The installer invoked SYSGEN to make a modification to a SYSGEN
internal file.
Action • Print file AUTOLOG.INSTALL.SYS to view detailed error from
SYSGEN.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
185 Message The installer encountered an error purging TARGVUF.
(INSTERR #185)
Cause The installer failed to purge the file TARGVUF.
Action • Document any error message text prior to the error.
• Examine file for accessors other than the installer.
• If file is being accessed, free up file.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
186 Message Error accessing installer variable: MPE_TARG_VUF. (INSTERR
#186)
Cause Could not retrieve the value of the indicated CI variable
MPE_TARG_VUF.
Action • Document any error message text prior to the error.
• Use SHOWVAR MPE_TARG_VUF to check the status of the variable.
• Print the INITCIVR.INSTALL. There should be a line with a SETVAR
command for the indicated variable. If the line does exist, execute
INITCIVR and run HPINSTAL again.
• If INITCIVR.INSTALL.SYS does not exist or does not contain the
SETVAR command for the listed CI variable, VSCLOSE both CD-ROM
volumes and follow the setup procedures in the HPINSTAL manual.
Run HPINSTAL from the start.