HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
357
153 Message The installer could not purge filename file. (INSTERR #153)
Cause The installer attempted to purge the old version of the file filename and
failed.
Action • Examine the file for accessors other than the Installer.
• If the file is being accessed, free it up.
• Take appropriate measures and run AUTOINST again.
• Contact the Response Center if further assistance is required.
154 Message AUTOGEN, AUTORLNK VUF MISMATCH (INSTERR #154)
Cause AUTOGEN and AUTORLNK from the PowerPatch tape should have the
same file vuuff. This error can only be caused if two different PowerPatch
tapes are in use.
Action For AUTOINST:
• Restore A@,F@ from the correct PowerPatch.
• Take appropriate corrective measures and run AUTOINST to start
installation again.
• Contact the Response Center if further assistance is required.
For HPINSTAL:
• Restart HPINSTAL; it will restore the files from the PowerPatch tape
again. If the error occurs again, contact the Response Center for
assistance.
155 Message Error while getting information from filename (INSTERR #155)
Cause A file system intrinsic failed on the named file.
Action If the file is an AUTOGEN, AUTODEP, or AUTORLNK file, restore the
file from the PowerPatch tape and restart. If it fails again, save the
displayed information files, patch and installation errors, and call the
Response Center.
156 Message Relinker patch patch-id not found in AUTORLNK (INSTERR #156)
Cause A relinker patch found in the AUTOGEN file is not found in the
AUTORLNK file.
Action Save the PATCHAUD file, the INSTERRS file, and call the Response
Center.
157 Message Error while creating AUXHDR. (INSTERR #157)
Cause The installer is trying to get information from the auxiliary header in the
OSSOM and failed while doing so.
Action Note the error messages, escape codes displayed, and contact the
Response Center.
158 Message Failed to Createprocess on AUTOSPTH. (INSTERR #158)
Cause Patch selector is trying to createprocess on AUTOSPTH to get relinker
information and the CREATEPROCESS intrinsic has failed.