HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
355
— Store user files to tape and them purge them. Restore the files
from tape at the end of the installation.
— Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
143 Message Rename of filename1 to filename2 failed. (INSTERR #143)
Cause The installer attempted to rename filename1 file to filename2 and was
unable to do so.
Action Check if a file named filename2 already exists. If so, purge it, and restart.
144 Message Tape VUF and OS VUF do not match (INSTERR #144)
Cause The PowerPatch tape being used is not meant for the current level of the
Operating System.
Action • Use the correct PowerPatch tape and restart the installer.
• Contact the Response Center if further assistance is required.
145 Message The installer failed to build an ASAINTFL file. (INSTERR #145)
Cause The installer was attempting to build a workfile: ASAINTFL, and failed.
Action • Check and correct errors reported to terminal screen.
• Check for free disk space on system. There are two methods for
obtaining additional disk space:
• Use the ALTERVOL command in VOLUTIL to set the permanent and
transient space allocation assignments to 100% on all system volumes
except LDEV 1.
— Store user files to tape and them purge them. Restore the files
from tape at the end of the installation.
— Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
146 Message The installer failed to build ASYSGNFL file. (INSTERR #146)
Cause The installer was attempting to build a workfile: ASYSGNFL, and failed.
Action • Check and correct errors reported to terminal screen.
• Check for free disk space on system. There are two methods for
obtaining additional disk space:
• Use the ALTERVOL command in VOLUTIL to set the permanent and
transient space allocation assignments to 100% on all system volumes
except LDEV 1.
— Store user files to tape and them purge them. Restore the files
from tape at the end of the installation.
— Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
147 Message The installer failed to STREAM the job indicated as
Current IFILE in the HPINSTFL file. (INSTERR #147)