HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
354
• Take appropriate corrective measures and run the installer again.
• If the file still fails to decrypt, it must be corrupted on the tape -- Call
the Response Center for further assistance.
136 Message Invalid patchtype for binary patch, patch type = patchtype.
(INSTERR #136)
Cause A Binary patch has been found with a patch type other than BA or BI.
Action Save PATCHAUD.INSTALL.SYS and contact the Response Center for
assistance.
137 Message BA-BI count mismatch. (INSTERR #137)
Cause Error while processing Binary patches.
Action Save PATCHAUD.INSTALL.SYS and contact the Response Center for
assistance.
138 Message 138 Not used
139 Message The installer could not find filename in DLGINFO. (INSTERR
#139)
Cause The installer could not find filename in the DLGINFO file. This is
typically caused by not purging the UNL.SYS, USL.SYS or UXL.SYS
groups on an UPDATE prior to running the installer. Another possibility
would be a corrupt DLGINFO.PUB.SYS file.
Action If the USL, UXL, UNL groups were not purged prior to starting the
installation, purge them and restart the installation procedures. If there is
still a problem, contact the Response Center for further assistance.
140 Message 140 Not used
141 Message The installer failed to STREAM SUPACCT. (INSTERR #141)
Cause The installer received a nonzero return status when it attempted to
stream SUPACCT.
Action • Ensure there are no STREAM UDCs.
• Check the STREAMS and SPOOLER functionality by streaming
SUPACCT.INSTALL.SYS manually (note that it should be a
temporary file).
• Check the file SUPACCT.PUB.SYS for a valid JOB card.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
142 Message The installer was unable to build filename. (INSTERR #142)
Cause The installer failed to build a permanent file using the BUILD command.
Action • Check for free disk space to build file. There are two methods for
obtaining additional disk space:
• Use the ALTERVOL command in VOLUTIL to set the permanent and
transient space allocation assignments to 100% on all system volumes
except LDEV 1.