HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
350
• Perform corrective action for SYSGEN.
• Ensure ASYSGNFL.INSTALL.SYS exists.
• Ensure group for SYSGEN has sufficient capabilities. (need CAP=PH).
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
110 Message Invalid product number prod_number. (INSTERR #110)
Cause Either an invalid product number was entered manually, or the local
PRODLIST file contains an invalid entry.
Action • If entering data from the terminal during HPINSTAL, run
HPINSTAL again and enter the correct product number.
• If using a PRODLIST file, modify the incorrect product number.
111 Message Unable to build file filename. (INSTERR #111)
Cause CUSTOM was unable to build the specified file. This may be due to an
existing file of the same name, or a lack of disk space to build the file.
Action • Ensure that no file of that name exists.
• Ensure that there is sufficient disk space to build the file by issuing
the BUILD command with the specified disc= filesize parameter. If you
can successfully build the file, back up your system and purge
unneeded files.
•Run HPINSTAL again.
• Contact the Response Center if further assistance is required.
112 Message Error: Failed to purge filename. (INSTERR #112)
Cause A call to the COMMAND or HPCICOMMAND intrinsic returned a
nonzero command error while attempting to purge the indicated filename.
Action Check the security and accessors of the filename listed in the error
message or simply purge the file manually. Take appropriate corrective
measures and run the installer again.
113 Message 113 Not used
114 Message Unable to locate PRODLIST. (INSTERR #114)
Cause There is no PRODLIST file in the local group
Action • Create a PRODLIST file containing the list of products.
•Run HPINSTAL again.
115 Message Please check the accuracy of this list against the
product list supplied with your CD-ROM. Re-run HPINSTAL,
making
necessary changes to the product list. Otherwise, please
contact
the Response Center. (INSTERR #115)
Cause The key for the disk drive computed by HPINSTAL differs from the one
entered.