HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
349
Cause The CREATEPROCESS intrinsic returned an error status when
attempting to execute LINKEDIT.PUB.SYS or AUTOLED.INSTALL.SYS.
If a special LINKEDITOR is used it is named AUTOLED.INSTALL.SYS.
Action • Check the returned CREATEPROCESS error in the MPE/iX
Intrinsics Reference Manual.
• Print file AUTOLOG.INSTALL.SYS to check for further errors.
• Check error message cause and action in the HP Link
Editor/iX Reference Manual.
• Ensure group for LINKEDIT has sufficient capabilities. (need
CAP=PH).
• If performing a PowerPatch operation:
— Verify that AUTOLED.INSTALL.SYS exists, if it is the one used.
— Print file AUTOLOG.INSTALL.SYS to check for further errors.
— Check error message cause and action in the HP
Link Editor/iX Reference Manual.
— Ensure the INSTALL.SYS group for AUTOLED has sufficient
capabilities. (need CAP=PH).
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
107 Message 107 Not used
108 Message Error trying to RUN SAINT.MPEXL.SYS. (INSTERR #108)
Cause Could not create SAINT process. Createprocess error: status
Action • The CREATEPROCESS intrinsic returned an error status when
attempting to execute SAINT.MPEXL.SYS.
• Check the returned CREATEPROCESS error in the MPE/iX
Intrinsics Reference Manual.
• Print file AUTOLOG.INSTALL.SYS to check for further errors.
• Perform corrective action for SAINT.
• Ensure ASAINTFL.INSTALL.SYS exists.
• Ensure group for SAINT has sufficient capabilities. (need CAP=PH).
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
109 Message Error trying to RUN SYSGEN.PUB.SYS. (INSTERR #109)
Cause Could not create SYSGEN process. Createprocess error: status
• The CREATEPROCESS intrinsic returned an error status when
attempting to execute SYSGEN.PUB.SYS.
• Check the returned CREATEPROCESS error in the MPE/iX
Intrinsics Reference Manual.
• Print file AUTOLOG.INSTALL.SYS to check for further errors.