HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
348
Cause The installer attempted to purge an old AUTOLOG file and failed.
Action • Examine file for accessors other than the installer.
• If file is being accessed, free up file.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
103 Message The installer failed to build AUTOLOG.INSTALL. (INSTERR #103)
Cause The installer failed to build the file AUTOLOG.INSTALL.
Action • Check for free disk space to build file. There are two methods for
obtaining additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the permanent
and transient space allocation assignments to 100% on all system
volumes except LDEV 1.
— Store user files to tape and them purge them. Restore the files
from tape at the end of the installation.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
104 Message The installer failed to open AUTOLOG.INSTALL with append
access. (INSTERR #104)
Cause The installer issued a file equation so that the file AUTOLOG can be used
as $STDOUT for the subsystems called by the installer.
Action •FILE Command Table is possibly full. Do a LISTEQ command to
determine which USER file equations can be RESET. RESET any
USER file equations.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
105 Message A CLEANXL failed on an NM Library. The installer cannot
continue.
(INSTERR #105)
Cause The installer called the link editor to perform a CLEANXL on either the
stated XL or the staged NL after purging SOMs and in preparation for
adding subsys or patched SOMs. The installer could have also called the
link editor to perform a CLEANXL on either the stated XL or the staged
NL prior to building the START IMAGE and then producing the CSLT.
Action • Print file AUTOLOG.INSTALL.SYS to view detailed error from link
editor, and to determine where in the installation/update/patch
process the CLEANXL was issued.
• Check error message cause and action in the HP Link
Editor/iX Reference Manual.
• Take appropriate corrective measures and run the installer again.
106 Message Error trying to RUN AUTOLED. (INSTERR #106) Could not
create AUTOLED process. Createprocess error: status