HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
339
— Store user files to tape and them purge them. Restore the files
from tape at the end of the installation.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
69 Message Copy of SPLINTR.PUB.SYS to SPLINTR.INSTALL.SYS failed.
(INSTERR #69)
Cause The installer was attempting to copy SPLINTR.PUB.SYS to
SPLINTR.INSTALL.SYS.
Action • Examine file SPLINTR.INSTALL.SYS for accessors other than the
installer.
• If file is being accessed, free up file.
• Check for free disk space to copy file, and if needed free up disk space.
There are two methods for obtaining additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the permanent
and transient space allocation assignments to 100% on all system
volumes except LDEV 1.
— Store user files to tape and them purge them. Restore the files
from tape at the end of the installation.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
70 Message A call to the LINKEDITOR by the installer failed. (INSTERR
#70)
Cause The link editor variables LKEDSTAT and/or LKEDCMD were checked
after a call to the link editor by the installer. The variables were found to
contain error values.
Action • Record the error messages preceding this message.
• Print file AUTOLOG.INSTALL.SYS to view detailed error from link
editor.
• Check error message cause and action in the HP Link
Editor/iX Reference Manual.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
71 Message The installer failed to purge TEMPNL when patching
the OS SOM. (INSTERR #71)
Cause The installer was attempting to purge an old work nl, TEMPNL.INSTALL
used when patching the OS SOM.
Action • Examine file TEMPNL.INSTALL.SYS for accessors.
• If accessors, free up file.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.