HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
333
Action • The inability to SETJCW CIERROR to a legal JCW range is an
indication of a corrupt session-level variable table or another serious
system problem.
• Document all messages prior to the error. Save the file
AUTOLOG.INSTALL.SYS. Report the problem to the Response
Center.
43 Message Error trying to RUN SOMPATCH.PUB.SYS. (INSTERR #43)
Could not create SOMPATCH process. Create process error:
status
Cause The CREATEPROCESS intrinsic returned an error status when
attempting to execute SOMPATCH.PUB.SYS.
Action • Verify sompatch_filename is on your system.
• Print file AUTOLOG.INSTALL.SYS to ascertain CREATEPROCESS
error or use the displayed error.
• Check the returned CREATEPROCESS error in the MPE/iX
Intrinsics Reference Manual.
• Perform corrective action for SOMPATCH.
• Ensure group for SOMPATCH has sufficient capabilities. (need
CAP=PH).
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
44 Message Error occurred while executing SOMPATCH commands. (INSTERR
#44)
Cause The installer invoked SOMPATCH to binary patch the NL in the local
group. SOMPATCH encountered an error and the installer trapped on the
error condition.
Action • Record all error messages on the screen.
• Check the JCW from SOMPATCH, PATCHJCW, with SHOWJCW.
• Print file AUTOLOG.INSTALL.SYS to view detailed error from
SOMPATCH.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
45 Message Error occurred while adding or deleting system programs
(INSTERR #45)
Cause The installer invoked SYSGEN to add or delete a system file. SYSGEN
encountered an error and the installer trapped on the error condition.
Action • Print file AUTOLOG.INSTALL.SYS to view detailed error from
SYSGEN.
• Take appropriate corrective measures and run the installer again.
• Contact the Response Center if further assistance is required.
46 Message Error executing SYSGEN commands while building the CSLT.
(INSTERR #46)