HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
326
:SETJCW STOREJCW OK
• If either of the commands are successful, run the installer again.
• Contact the Response Center if further assistance is required.
16 Message The installer failed to checksum the SL. (INSTERR #16)
Cause The checksum procedure failed to obtain checksums from the SL.
Action • Enter LISTF SL.INSTALL.SYS to verify the copy of the SL exists.
• Verify that the SEGMENTER can access the SL outside of the
installer:
:SEGMENTER
-SL SL.INSTALL.SYS
-LISTSL
Press
CTRL Y
to stop listing all the SL segments.
• Run the installer again.
• Contact the Response Center if further assistance is required.
17 Message The installer failed to lock SL.PUB.SYS. (INSTERR #17)
Cause The installer failed to execute the command FILE SL.PUB.SYS;LOCK .
Action • Attempt the file command manually outside of the installer.
• Take appropriate corrective measures, and run the installer again.
• Contact the Response Center if further assistance is required.
18 Message The installer failed to copy SL.PUB.SYS. (INSTERR #18)
Cause The installer failed to execute the command COPY SL.PUB.SYS, SL to
obtain a local copy of the SL.
Action • Ensure the file equation FILE SL.PUB.SYS;LOCK exists with the
LISTEQ command.
• Ensure SL.PUB.SYS exists with the LISTF command.
• Check for free disk space to copy file. There are two methods for
obtaining additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the permanent and
transient space allocation assignments to 100% on all system
volumes except LDEV 1.
— Store user files to tape and them purge them. Restore the files
from tape at the end of the installation.
• Check if target file SL.INSTALL.SYS already exists. Purge the
SL.INSTALL.SYS file.
• Take appropriate corrective measures, and run the installer again.
• Contact the Response Center if further assistance is required.
19 Message The installer failed to copy XL.PUB.SYS. (INSTERR #19)
Cause The installer failed to execute the command COPY XL.PUB.SYS, XL to
obtain a local copy of the XL.
Action • Ensure XL.PUB.SYS exists with the LISTF command.