HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
324
— Use the ALTERVOL command in VOLUTIL to set the permanent
and transient space allocation assignments to 100% on all system
volumes except LDEV 1.
— Store user files to tape and them purge them. Restore the files
from tape at the end of the installation.
• Transmission errors - Clean tape heads and check for hardware
errors.
• Corrupt files - Manually RESTORE the corrupt files from the
PowerPatch tape. If successful, this indicates there were transmission
errors.
• Take appropriate corrective measures, and run the installer again.
• Contact the Response Center if further assistance is required.
8 Message Add-on cannot be done without an ADD-ON tape. (INSTERR #8)
Cause Occurs in AUTOINST only: AUTOINST received a negative response to
the query about a SUBSYS tape in the installation package while
performing the ADD-ON option.
Action • Do not select the ADD-ON option unless there is a SUBSYS tape in
the installation package.
• Respond with YES to the SUBSYS tape query if there is a SUBSYS
tape in the installation package.
9 Message SUPACCT has been purged from system. (INSTERR #9)
Cause The installer could not find SUPACCT.PUB.SYS.
Action • Restore @ACCT.PUB.SYS from the FOS tape. Be sure to use the
appropriate FOS tape.
• Run the installer again after restoring the file.
• Contact the Response Center if further assistance is required.
10 Message STREAMS device not enabled. The installer cannot continue.
(INSTERR #10)
Cause The installer could not obtain the LDEV number for the STREAMS
device.
Action • Ensure that a STREAMS device is configured and is enabled.
• The STREAMS device no longer needs to be LDEV 10.
• Take appropriate corrective measures, and run the installer again.
• Contact the Response Center if further assistance is required.
NOTE INSTERR #12 applies only to AUTOINST, not HPINSTAL.
11 Message 11 Not used
12 Message This installer is supported on Release 2.2 or later
ONLY. (INSTERR #12)