HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
322
• Use an appropriate text editor to inspect the offline listing generated
by RESTORE. Identify the spoolfiles having RESTORE status by
using the command:
:LISTSPF SELEQ=[FILEDES=OFFLINE]
The last spoolfile displayed will contain the output listing from the
RESTORE command. The error messages in this file will show the
problems encountered in restoring files from the FOS tape.
• Missing files - Manually RESTORE missing files from the FOS tape.
• Out of disk space - There are two methods for obtaining additional
disk space:
— Use the ALTERVOL command in VOLUTIL to set the permanent
and transient space allocation assignments to 100% on all system
volumes except LDEV 1.
— Store user files to tape and them purge them. Restore the files
after installation.
• Transmission errors - Clean tape heads and check for hardware
errors.
• Corrupt files - Manually RESTORE the corrupt files from the FOS
tape.
• Unexpected end of file marker found (S/R 9060). This special case will
not cause the entire Restore to fail. You may not see INSTERR #4,
however, a later step will fail due to missing files. If the device is a
DDS, specifically an HPC1503B or HPC1520B, it is likely that you
have encountered a DDS firmware problem. Contact your HP
representative for further assistance.
• Take appropriate corrective measures, and run the installer again.
• Contact the Response Center if further assistance is required.
5 Message The SUBSYS tape has not been successfully restored.
To continue with the installation, consult the customer
installation
procedures. (INSTERR #5)
Cause The JCW STOREJCW was nonzero after the installer executed the
following STORE command to restore the SUBSYS or ADDON tape:
:RUN STORE.PUB;INFO= RESTORE &
SUBSYS;@.@.@;CREATE;SHOW=OFFLINE
Action • Ensure that a device with class LP is included in your configuration.
• Use an appropriate text editor to inspect the offline listing generated
by RESTORE. Identify the spoolfile having RESTORE status by using
the command:
:LISTSPF SELEQ=[FILEDES=OFFLINE]
The last spoolfile displayed will contain the output listing from the
RESTORE command. The error messages in this file will show the
problems encountered in restoring files from the SUBSYS tape.