Manualshelf

HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

ManualsBrandsHP ManualsSoftwareMPE/iX 7.0 Operating System
311312313314315316317318319320
Appendix H
Error Messages and Warnings
SETUP Error Messages (SETERR)
317
26 Message Unable to set file equation for OLDACCTS data file.
SETUP will terminate. Follow the instructions in your
installation
manual to continue. (SETERR #26)
Cause SETUP.INSTUTIL failed when attempting to set a file equation for
OLDACCTS.
Action • Do a LISTEQ to determine which file equations have been set.
• Reset the files for which you no longer need file equations. (If no file
equations are needed, do a RESET @.)
• Contact the Response Center if further assistance is required.
27 Message SETUP could not purge its old error log SETUPLOG. SETUP will
terminate. Follow the instructions in your installation
manual to
continue. (SETERR #27)
Cause A SETUPLOG existed from a previous execution of SETUP.INSTUTIL,
and it could not be purged.
Action • Ensure that the file is not busy.
• Ensure that the file is not a temporary file.
• Purge the SETUPLOG.
• Execute SETUP.INSTUTIL.
• Contact the Response Center if further assistance is required.
28 Message Unable to set file equation for log file, SETUPLOG.
SETUP will terminate. Follow the instructions in your
installation manual to continue. (SETERR #28)
Cause SETUP.INSTUTIL failed when attempting to set a file equation for
SETUPLOG.
Action • Do a LISTEQ to determine which file equations have been set.
• Reset the files for which you no longer need file equations. (If no file
equations are needed, do a RESET @.)
• Contact the Response Center if further assistance is required.
29 Message SETUP could not purge its old data file, INITCIVR.
SETUP will terminate. Follow the instructions in your
installation manual to continue. (SETERR #29)
Cause A INITCIVR existed from a previous execution of SETUP.INSTUTIL, and
it could not be purged.
Action • Ensure that the file is not busy.
• Ensure that the file is not a temporary file.
• Purge INITCIVR.
• Execute SETUP.INSTUTIL.
• Contact the Response Center if further assistance is required.