HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
SETUP Error Messages (SETERR)
310
SETUP Error Messages (SETERR)
1 Message You must be logged on to MANAGER.SYS,INSTALL to set up for
HPINSTAL. SETUP will terminate. Follow the instructions in
your installation manual to continue. (SETERR #1)
Cause You have either logged on as someone other than MANAGER.SYS, or you
are not in the INSTALL group.
Action • Log on as MANAGER.SYS,INSTALL and execute SETUP.INSTUTIL.
• Contact the Response Center if further assistance is required.
2 Message The group CD vuuff containing the HPINSTAL fileset could not
be initialized. SETUP will terminate. Follow the instructions
in your installation manual to continue. (SETERR #2)
Cause SETUP was unable to access the group CD vuuff .SYS on the compact disk
(CD-ROM) containing the HPINSTAL file set.
Action • VSCLOSE the CD-ROM disk labelled volume 1 (MPE_C-45.00_1).
• PURGEGROUP CD vuuff
• VSOPEN the compact disk
• Execute SETUP.INSTUTIL
• If SETUP is still unable to initialize the CD vuuff .SYS group, contact
the Response Center for further assistance.
3 Message The HPINSTAL data file, GRPNAMES, is non-existent. SETUP
will terminate. Follow the instructions in your installation
manual
to continue. (SETERR #3)
Cause Either the file is non-existent, or SETUP is accessing the file in an invalid
location.
Action • Use the LISTEQ command to determine if a file equation exists. If it
does exist, reset GRPNAMES.
• Execute SETUP.INSTUTIL.
• If GRPNAMES still cannot be located, contact the Response Center.
4 Message You must execute SETINIT to complete the SETUP. SETUP will
terminate. Follow the instructions in your installation
manual to
continue. (SETERR #4)
Cause An old accounting structure was encountered when executing SETUP.
SETUP cannot process successfully, therefore, you will be required to
execute an additional script, SETINIT. SETINIT will purge the old
accounting structure, then automatically execute SETUP.INSTUTIL
Action • Execute the script, SETINIT.INSTALL.
• Contact the Response Center if further assistance is required.