HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix G
HP Stage/iX Reference
HP Stage/iX Commands
285
STAGEMAN> errmsg 1170
MESSAGE:
The HP Stage/iX Globals file is temporarily in use by another process. Can't complete
command. (STAGEMAN 1170)
CAUSE:
STAGEMAN could not open the HP Stage/iX Globals file because it was held open
exclusively by another process at the time. The other process was most likely STAGEMAN
(or HP Patch/iX) being run in another job or session (STAGEMAN always opens the
Globals file for exclusive access).
ACTION:
Either terminate the additional STAGEMAN process, or allow the command being executed
by that process to complete.
EXIT
The EXIT command (abbreviated E or EX) exits the STAGEMAN utility. You must have System Manager (SM) or
System Operator (OP) capability to execute this command.
Syntax
EXIT
Parameters
(none)
Example
To exit from STAGEMAN, enter:
STAGEMAN> EXIT
EXPERT
The EXPERT command is used to put STAGEMAN into expert mode. There are several STAGEMAN commands that
extend the basic STAGEMAN functionality which require you to be in EXPERT mode. All expert mode commands
require SM capability. The EXPERT command itself requires SM capability to execute.
The following commands are allowed in expert mode only:
Table G-5 Commands Only Available in Expert Mode
Command Description
STAGEFILE (SF) Put a file in a staging area.
DELETEFILE (DF) Delete a file from a staging area.
CHANGEFILE (CF) Change the attributes of a staged file.
SETDEFAULT (SETD) Set the default attributes for a particular file.
SHOWDEFAULT (SHOWD) Display the default attributes for a file.