HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix E
CD-ROM Resources
Adding a CD-ROM Drive
249
io>AD LDEV= ldev PATH= path ID= prod#
where:
ldev logical device number of the CD-ROM drive.
path hardware path to the CD-ROM drive (e.g., 36.1.3 or 52.4).
prod# identification number of the CD-ROM drive (i.e., for HP-IB: HPC1707A; for HP SCSI:
HPA1999A; for Toshiba 3401 SCSI: CD-ROM-XM-3401TA or CD-ROM-XM-4101TA).
SCSI Example:
:SYSGEN
sysgen> IO
(first verify that path 52 has SCSI-DAM as PMGR)
io> LPATH 52 ***SAMPLE DATA***
(Add the path for the CD-ROM with a pseudo manager as
the ID)
io> APATH PATH=52.3 ID=PSEUDO PMGR=TRANSPARENT_MGR
(If you have a second CD-ROM to configure, then do
the same for the other path:)
io> APATH PATH=52.4 ID=PSEUDO PMGR=TRANSPARENT_MGR
(then add the devices; `.0' is appended to path
identifier)
io> ADEVICE LDEV=11 PATH=52.3.0 CLASS=DISC ID=HPA1999A
LMGR=LOGICAL_DEVICE_MANAGER PMGR=SCSI_DISC_DM
(then do the same for LDEV 12)
io> ADEVICE LDEV=12 PATH=52.4.0 CLASS=DISC ID=HPA1999A
LMGR=LOGICAL_DEVICE_MANAGER PMGR=SCSI_DISC_DM
6. Hold the changes you just made, exit the IO configurator, keep the new configuration, and exit SYSGEN:
io> HOLD
io> EXIT
sysgen> KEEP CONFIG
(Keep the changes to the current config group.
This assumes the group name is CONFIG.SYS.)
sysgen> EXIT
7. Shut down the computer system:
CTRL A
=SHUTDOWN
After you see the message SHUT 6, power off the computer.
8. Connect the CD-ROM drive to the card using the path you configured.
9. Set the voltage selector switch, if necessary, on the back of the CD-ROM drive. It should be set correctly.
10. If installing a SCSI CD-ROM drive, be sure that the SCSI bus is terminated properly at each end of the
bus.
11. Power on the CD-ROM drive.
12. Power on the computer and boot the system from the primary path. The boot message varies depending
on the system model.
If you system asks you to enter the boot path, enter the primary boot path.
If your system asks “Boot from primary path?” respond Y.
Enter Y to Interact
with IPL (or ISL)? if it appears on your screen.
13. Verify the I/O configuration using ODE: