HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix D
Backdating Your System
Finishing Up
223
As appropriate to your system, do either Step a, b, or c:
a. For HP 3000 Series 99X:
CTRL-B
CM>SP
SP>RS
Enter Y to HARD BOOT the computer system.
b. For HP e3000 N-Class, A-Class
CTRL-B
Service Processor login:
Service Processor password:
If you get the following prompt, then enter the characters ‘Ctrl-E c f’ to gain write access to the GSP.
[Read only - use ^Ecf for console write access.]
GSP>RS
c. For all other systems:
CTRL-B
CM>RS
If the system does not respond, press the reset button, key switch, or on/off switch as appropriate for your
system.
Enter Y to confirm restarting the system.
3. Boot the system from the primary boot path.
a. Boot messages can vary, depending on the system model.
b. Enter Y to the Interact with IPL? prompt, if it appears on your screen.
The system boots from disk. After some activity the ISL prompt displays.
4. At the ISL prompt, enter:
ISL>START NORECOVERY
5. Confirm the date and time.
6. Log on.
:HELLO MANAGER.SYS;HIPRI
Restart System Functions
Refer to “Restarting Selected System Functions” in Chapter 6, “Finishing the Process,” for additional
information about any of these steps.
1. On local systems power cycle the DTCs. On remote systems reset DTCs.
If you are using OpenView DTC Manager, the DTCs do not need to be power cycled.
To power cycle all DTCs:
a. Turn DTC off.
b. Turn DTC on.
Power cycling each DTC enables the new download file and the DTC configurations to be downloaded to
the DTC(s). To reset DTCs: