HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix D
Backdating Your System
Performing the Backdate
211
2 SUBSYS (Add-On) and PowerPatch
3 FOS, SUBSYS, and PowerPatch
4 FOS, SUBSYS, (Installation only)
5 SUBSYS only, (Add-on only)
6 Exit
Enter your choice 4
6. Reply to prompt for LDEV number.
Press Return to use the default device class TAPE or enter the LDEV number of the device where you
want the CSLT to be created. The device you specify applies to all tape requests.
CAUTION Failure to specify a valid tape LDEV number will result in a program hang while writing to
tape. If this occurs, a tape request will keep reappearing and will not take the specified
LDEV number as input.
7. If you receive an out of disk space message.
a. Refer to the action statement of the error message in Appendix H, “ Error Messages and Warnings.”
b. When you find the required disk space, issue the Autoinst command again.
8. Restore FOS files.
This step takes about 20–45 minutes.
a. Mount FOS tape and reply to tape request when the following message displays.
Mount the FOS tape and put the tape drive online. The files from
the FOS tape will now be restored.
**** PLEASE STAND BY ****
The FOS tape files are being restored.
`CREATE' OPTION DEFAULTING TO `CREATE=ACCOUNT,GROUP,CREATOR'
BASED ON YOUR CAPABILITIES (S/R 502)
STORE/RESTORE VERSION A.nn.nn (C) HEWLETT-PACKARD CO.
b. Reply to the tape request.
c. Dismount the FOS tape when the restore complete message displays.
The files from the FOS tape were successfully restored.
AUTOINST creates the accounting structure. Progress messages display throughout this 5 minute
process. The ending message is:
The accounting structure has been successfully created.
9. Respond to SUBSYS prompt.
If you have a SUBSYS, enter Y at the prompt, and proceed to Step 10.
If you do not have a SUBSYS, enter N at the prompt, and proceed to Step 11.
Has a SUBSYS tape been included in your installation package
(y/n)?
10. Restore SUBSYS files, if you have purchased products to add-on to your system software.
This step takes about 20–45 minutes.
a. Mount SUBSYS tape and reply to tape request (for SUBSYS and PowerPatch tape, as applicable)
when the following message displays.