HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix D
Backdating Your System
Performing the Backdate
210
:HELLO MANAGER.SYS,INSTALL;HIPRI
:LIMIT 1,1
:SPOOLER LP;OPENQ
:STREAMS streams_device
where streams_device is the device number. A common streams_device value is 10.
An LP device must be configured in SYSGEN. Already spooled and streamed messages might display.
Ignore the group out of connect time warning, if it displays.
2. Enter a DSTAT command to verify a status of master for the disk drives. All system volumes showing a
status of LONER must be added using the VOLUTIL utility.
3. Add system volumes. Use scratchvol and newvol commands.
4. Check all volumes to confirm they are configured correctly. Use the DSTAT command.
:DSTAT ALL
Restore FOS and SUBSYS
Refer to “Creating the CSLT Using AUTOINST” in Chapter 5, “Modifying Your System,” for additional
information about these steps.
AUTOINST sets up the necessary environment, restores files, creates the accounting structure for the
installation, and creates a CSLT.
1. Change to group install.
:CHGROUP INSTALL
2. Run AUTOINST.
:RUN AUTOINST.INSTALL.SYS
3. If you receive a missing capabilities message:
Program requires more capabilities than group is allowed.
(LDRERR505)
Native mode loader message 505 UNABLE TO LOAD PROGRAM TO BE
RUN. (CIERR 625)
a. Use CHGROUP to change to the PUB.SYS group.
:CHGROUP PUB
b. Use ALTGROUP to add the BA, IA, PM, MR, DS, and PH capabilities to the INSTALL group
:ALTGROUP INSTALL; CAP=BA,IA,PM,MR,DS,PH
c. Use CHGROUP to return to the INSTALL.SYS group.
:CHGROUP INSTALL
4. If you receive an out of disk space message.
a. Refer to the action statement of the error message in Appendix H, “ Error Messages and Warnings.”
b. When you find the required disk space, issue the command again.
c. Purge staging groups UNL, USL, UXL
5. Select option 4 “FOS, SUBSYS” and reply to the tape request.
Please choose and enter the number corresponding to the software
you want to install.
1 PowerPatch Only