HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix A
Manually Installed Products
Configuring File Transfer Protocol (FTP)
179
Configuring File Transfer Protocol (FTP)
To configure FTP so it is enabled after the update or install of the latest version of MPE/iX:
1. Remove any passwords from MANAGER.SYS.
2. Stream FTPCNFJ.ARPA.SYS.
:STREAM FTPCNFJ.ARPA.SYS.
This will add FTP entries to the appropriate Internet Super Daemon files.
For more information on the specifics of these entries, refer to the Installing and Managing HP ARPA File
Transfer Protocol Network Manager’s Guide, in the chapter “Starting FTP”.
3. Reset any passwords on MANAGER.SYS that Step 1 removed.