HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Chapter 6
Finishing the Process
6.8 Restarting Selected System Functions
155
c. For each DTC, type:
(reset)
Ldev#
POrt#,#,#
SNp #,# (X.25 card in DTC)
VC #,#,#,
Slc #,# (multiplexer card in DTC)
DTc #
(Carriage return to exit)
?DTCnn
Where nn is the DTC number.
5. Start Internet Services.
If you have any Internet Services configured (telnet, ftp, etc.), stream the Internet Super Daemon job.
:STREAM JINETD.NET.SYS
For more information, refer to the Configuring and Managing MPE/iX Internet Services manual.
6. Turn HP Predictive Support back on.
If you are using the HP Predictive Support software as part of your Hewlett-Packard hardware support
contract, ensure that an HP Predictive Support run completes successfully.
a. Issue the HP Predictive Support command:
:RUN PSCONFIG.PRED.SYS
This run of HP Predictive Support may include a transfer of files to the Hewlett-Packard Response
Center. If a transfer is needed, be sure it completes because the system update overwrites the
information in the file PSDCFILE.PRED.SYS.
b. Select item 4, Configuration, from the Main menu.
c. Select item 5, Schedule, from the Configuration Options menu.
d. Select item 1, Schedule (ON/OFF), from the Schedule menu.
e. Set the preference, at the prompt, type ON:
Type schedule preference (on/off) or // to cancel: __
f. Exit the program, at the prompt, type EXIT:
Type an item number, an item key, or a command: __
g. Save the values, at the prompt, type YES:
Do you wish to save these values (Y/N)? __
• Restarting Selected System Functions completed. Go to the next section on your checklist.