HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Chapter 6
Finishing the Process
6.8 Restarting Selected System Functions
154
6.8 Restarting Selected System Functions
To restart selected system functions:
1. Log on.
:HELLO MANAGER.SYS;HIPRI
On local systems power cycle the DTCs. If you are using OpenView DTC Manager, the DTCs do not need
to be power cycled. On remote systems reset DTCs.
To power cycle all DTCs:
a. Turn DTC off.
b. Turn DTC on.
Power cycling each DTC enables the new download file and the DTC configurations to be downloaded to
the DTC(s).
2. Purge groups.
:PURGEGROUP USL
:PURGEGROUP UXL
:PURGEGROUP UNL
3. Start data communications.
If you have NS 3000/iX configured, bring up the configured network interfaces. For more information,
refer to the HP e3000/iX Network Planning, and Configuration Guide.
NOTE Use the same names for the network interfaces that were used in your configuration.
• For example, if you have configured network interfaces with the names LOOP and LAN1, enter:
:NETCONTROL START;NET=LOOP
:NETCONTROL START;NET=LAN1
:NSCONTROL START
• If you have configured only the router network interface with the name ROUTER1, enter:
:NETCONTROL START;NET=ROUTER1
:NSCONTROL START
NOTE JFTPSTRT.ARPA.SYS is no longer part of the FTP product. It is no longer necessary to
stream JFTPSTRT.ARPA.SYS. For FTP to work, you DO need to follow the instructions
in Appendix A “Configuring File Transfer Protocol FTP”.
4. To reset DTCs on remote systems:
a. Type:
:termdsm.diag.sys
b. At the termdsm prompt, type R:
Connect DIag DTc DUmp EEprom Help Reset Status Trace EXit ?R