HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Chapter 5
Modifying Your System
5.16 Rerunning HPINSTAL
137
5.16 Rerunning HPINSTAL
To rerun hpinstal and finish applying the CSLT:
1. Remount the CSLT created by HPINSTAL.
2. Reinvoke HPINSTAL and resume previous installation.
:HPINSTAL
3. If you are performing an Add-on or Update task, go to Step 4.
If you are performing a Modify Remote System task, go to Step 5.
Add-on Tasks, Update Tasks
4. Resume previous installation.
a. Type YES at the prompt.
If the CSLT was created on the system you are updating, the system displays a message saying it
located an old audit trail of an incomplete installation (that is, HPINSTFL.INSTALL.SYS). You must
respond YES and resume the installation to complete the task.
b. Go to Step 5.
However, if you accidentally responded NO, you can continue by performing the following:
a. Exit hpinstal by selecting Option 8.
b. Reinvoke HPINSTAL using the recovery parameter:
:HPINSTAL RECOVERY
c. Go to Step 5.
5. If you are applying a CSLT to a Remote system, go to Step 6.
If you are performing an Add-on or Update task for the local system only, go to Step 8.
Remote Tasks
6. Deny any previous installation, if it exists.
Type NO at the prompt.
If you are modifying a remote system (the CSLT was created on a local system) and the following message
displays, it indicates that HPINSTAL located an old audit trail of an incomplete installation (that is,
HPINSTFL.INSTALL.SYS). You must respond NO to properly complete your remote installation task.
7. From the HPINSTAL menu, select option 5, “Complete the update of this system using a CSLT created on
another system,” to start the update process on the remote system.
1 Update this system
2 Update this system and install patches from a PowerPatch tape
3 Create a CSLT for another system
4 Create a CSLT with PowerPatch patches for another system
5 Complete the update of this system using a CSLT created on
another system
6 Add SUBSYS products to this system
7 Add SUBSYS products and install patches from a Powerpatch