HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Chapter 4 87
Preparing Your System
4.6 Creating the CSLT using HPINSTAL
c. Respond Y to accept the list of qualified patches, as prompted:
Do you wish to continue with the installation of the patches listed
above(Y)?>>
d. Remount the PowerPatch tape, as prompted;
Mount the POWERPATCH tape and put the tape drive online.
The files from the POWERPATCH tape will now be restored.
e. Reply to the tape request.
f. Proceed to Step 13.
13.Create the CSLT.
Mount a write-enabled tape on the appropriate tape drive and reply to the tape request,
as prompted. This can take up to two and a half hours.
a. hpinstal determines the files that belong to your selected list of products.
Resolving product-level dependencies... DONE
Determining the subsystem files to be installed
... DONE
b. hpinstal stages system libraries and creates the CSLT. This can take from one up to
two and a half hours.
Making a temporary copy of the SL... DONE
Making a temporary copy of the XL... DONE
Making a temporary copy of the NL... DONE
The installer will next update staged copies of
the System SL, XL, and NL
c. HPINSTAL updates the temporary copies of the system libraries and displays status
messages:
Installing the SUBSYS and patch code, if any . . .
Modifying SL.INSTALL.SYS ... done
Translating SL.INSTALL.SYS ... done
Modifying XL.INSTALL.SYS ... done
Modifying NL.INSTALL.SYS ... done
Modifying System Intrinsics ... done
Creating a new START PME ... done
Creating the CSLT ...
Insert the second CD-ROM disk if prompted, then press [Return].
The installer is done with the CD-ROM currently mounted.
Please remove the CD-ROM and insert the second CD-ROM, marked
MPE_ v.uu.ff _2.
When the second CD-ROM volume is mounted, press RETURN to
continue >>