HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

414 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
• Once the system is up, log on to the system as
MANAGER.SYS,INSTALL, start the spooler, and
enable the streams device.
• Run HPINSTAL again.
• Contact the Response Center if further assistance is
required.
203 Message The file TARGVUF.PUB.SYS is missing. (INSTERR
#203)
Cause This file is installed on a system as a result of performing
an UPDATE with the CSLT/STORE tape created during
Phase 1 of HPINSTAL. HPINSTAL looks for this file prior
to completing the update with FOS, STORE, and SUBSYS
components, to ensure the operating system has been
UPDATEd to the appropriate level.
Action • Halt the system and perform an UPDATE with the
CSLT/STORE tape created during Phase 1 of
HPINSTAL.
• Start the system.
• Once the system is up, log on to the system as
MANAGER.SYS,INSTALL, start t he spooler, and
enable the streams device.
• Run HPINSTAL again.
• Contact the Response Center if further assistance is
required.
204 Message Error while attempting to compare your system's
build
id with that of the release on the CSLT. (INSTERR
#204)
Cause HPINSTAL is unable to successfully compare the release
v.uu.ff of your system with the release v.uu.ff for which
this CSLT/STORE tape was created.
Action • Halt the system an perform an UPDATE with the
CSLT/STORE tape created during Phase 1 of
HPINSTAL.
• Start the system.
• Once the system is up, log on to the system as
MANAGER.SYS,INSTALL, start t he spooler, and
enable the streams device.
• Run HPINSTAL again.
• Contact the Response Center if further assistance is
required.