HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix H 413
Error Messages and Warnings
Installer Error Messages (INSTERR)
199 Message 199 Not used
200 Message Failed to retrieve the OS build ID. (INSTERR
#200)
Cause The installer failed to access the MPE/iX Operating
System and Release IDs of your system.
Action • Log on as MANAGER.SYS,INSTALL to your MPE/iX
environment.
• Rerun the tool.
• Contact the Response Center if further assistance is
required.
201 Message Your system is currently running software newer
than
the release for which the CSLT was created. If
you want to continue,
match the build version of your system to the one
reflected in the
file TARGVUF.PUB.SYS. (INSTERR #201)
Cause Your system has been UPDATED with a newer MPE/iX
release than the one for which this CSLT/SOTRE tape was
created.
Action • If your wish to backdate your system to the MPE/iX
release contained on the CSLT/STORE tape, follow the
instructions outlined in chapter entitled Backdating
Your System of this manual.
• Contact the Response Center if further assistance is
required.
202 Message The build of your system suggests that you did
not
update from the CSLT before invoking HPINSTAL.
Please refer to the
installation manual. (INSTERR #202)
Cause HPINSTAL fails when an attempt is made to complete the
update of a system by invoking HPINSTAL a second time
prior to UPDATing the system with the combined
CSLT/STORE tape created by HPINSTAL during Phase 1.
HPINSTAL makes this determination by comparing the
version of your current MPE/iX release with the version of
the release on the combined CSLT/STORE tape.
Action • Halt the system and perform an UPDATE with the
CSLT/STORE tape created during Phase 1 of
HPINSTAL.
• Start the system.