HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

398 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
to 100% on all system volumes except LDEV 1.
Store user files to tape and them purge them.
Restore the files from tape at the end of the
installation.
Take appropriate corrective measures and run the
installer again.
Contact the Response Center if further assistance is
required.
143 Message Rename of filename1 to filename2 failed.
(INSTERR #143)
Cause The installer attempted to rename filename1 file to
filename2 and was unable to do so.
Action Check if a file named filename2 already exists. If so, purge
it, and restart.
144 Message Tape VUF and OS VUF do not match (INSTERR #144)
Cause The PowerPatch tape being used is not meant for the
current level of the Operating System.
Action Use the correct PowerPatch tape and restart the
installer.
Contact the Response Center if further assistance is
required.
145 Message The installer failed to build an ASAINTFL file.
(INSTERR #145)
Cause The installer was attempting to build a workfile:
ASAINTFL, and failed.
Action Check and correct errors reported to terminal screen.
Check for free disk space on system. There are two
methods for obtaining additional disk space:
Use the ALTERVOL command in VOLUTIL to set the
permanent and transient space allocation assignments
to 100% on all system volumes except LDEV 1.
Store user files to tape and them purge them.
Restore the files from tape at the end of the
installation.
Take appropriate corrective measures and run the
installer again.
Contact the Response Center if further assistance is
required.
146 Message The installer failed to build ASYSGNFL file.
(INSTERR #146)