HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Chapter 2 39
Task Checklists
Checklist F. Add-on with CD-ROM
Checklist F. Add-on with CD-ROM
Use this task checklist if your source material is on CD-ROM and you are using CSLT
tape to:
• Add-on purchased products
• Add-on purchased products and apply PowerPatch patches
NOTE You cannot apply Reactive patches at the same time you are using CD-ROM
source material to add-on purchased products to your system. You must apply
Reactive patches after you update the system. To apply Reactive patches
(after you update the system), refer to the Checklist A, “Manage Patches,” or
Checklist B, “Manage Patches by Staging Area.”
Print a copy of this checklist for each system that you are applying add-on products to.
Read and perform the steps only in the following sections:
Begin Preparation Tasks.
Does not require exclusive access to the system.
Chapter 3 , “Planning for Your Task.”
— 3.1 Verifying Required Materials
— 3.2 General Planning Tasks
— 3.3 CD-ROM Planning Tasks
— 3.4 Checking Tape Media
— 3.6 Estimating Disk Space
Record contiguous disk space:
Record non-contiguous disk space:
Chapter 4 , “Preparing Your System.”
— 4.3 Preparing to Run HPINSTAL
Record CD
v.uu.ff version level:
— 4.6 Creating the CSLT using HPINSTAL
Record manually installed products:
— 4.12 Reserving Disk Space for CD-ROM Tasks
Record contiguous disk space:
Record non-contiguous disk space:
Preparation Tasks completed.
Schedule downtime for exclusive access.
Begin Exclusive Access Tasks.
Chapter 5 , “Modifying Your System.”