HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix H 385
Error Messages and Warnings
Installer Error Messages (INSTERR)
required.
91 Message Error while issuing file equation for the SL
library.
(INSTERR #91)
Cause The installer attempted to issue the file equation:
:FILE SL.PUB.SYS=SL
(SL being in the local group INSTALL.SYS), prior to
calling SYSGEN to create the CSLT.
Action • FILE Command Table is possibly full. Do a LISTEQ
command to determine which USER file equations can
be RESET. RESET any USER file equations.
• Take appropriate corrective measures and run the
installer again. The installer will reissue any needed
file equations.
• Contact the Response Center if further assistance is
required.
92 Message Error while issuing file equation for the START
IMAGE. (INSTERR #92)
Cause The installer attempted to issue the file equation:
:FILE START.MPEXL.SYS=START
(START being in the local group INSTALL.SYS), prior to
calling SYSGEN to create the CSLT.
Action • FILE Command Table is possibly full. Do a LISTEQ
command to determine which USER file equations can
be RESET. RESET any USER file equations.
• Take appropriate corrective measures and run the
installer again. The installer will reissue any needed
file equations.
• Contact the Response Center if further assistance is
required.
93 Message Error while issuing file equation for SYSGTAPE.
(INSTERR #93)
Cause The installer attempted to issue the file equation:
FILE SYSGTAPE;DEV= XXX
Where XXX is the LDEV number chosen at the start of the
installation, as the LDEV number where SYSGEN would
create the CSLT.
Action • FILE Command Table is possibly full. Do a LISTEQ
command to determine which USER file equations can
be RESET. RESET any USER file equations.