HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

372 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
specific error.
• Check for additional errors in file
SLOUTPUT.OUT.HPSPOOL.
• Take appropriate corrective measures and run the
installer again.
• If you are patching an MPE/iX system release 4.0 or
later, ensure that the version of AUTOINST you are
running is D.00.05 or later. If the AUTOINST version is
earlier than D.00.05, restore A@.F@ from the
PowerPatch tape, and run AUTOINST again.
• Contact the Response Center if further assistance is
required.
53 Message Patching INTRINSIC without correct component
type. (INSTERR #53)
Cause The installer encountered an error in processing the file
TMPSTR00. TMPSTR00 contains entries for both
Compatibility Mode (CM) and Native Mode (NM) intrinsic
files to be patched. The installerencountered an entry that
was not a CM or NM intrinsic file.
Action • If this error is produced, please document all messages
prior to the error.
• Save the file AUTOLOG.INSTALL.SYS, and the file
TMPSTR00.INSTALL.SYS. Report the problem to the
Response Center for assistance.
54 Message 54 Not used
55 Message Setting file equation SYSINTR failed. (INSTERR
#55)
Cause Setting the SYSINTR file equation required by the NM
intrinsic patcher ABLDINTX.INSTALL.SYS failed.
Action • FILE Command Table is possibly full.
• Check if any further file commands can be entered with
the FILE command.
• RESET any USER file equations.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required. The installer will reissue any needed file
equations.
56 Message Setting file equation SYSINTRN failed. (INSTERR
#56)
Cause Setting the SYSINTRN file equation required by the NM