HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix H 359
Error Messages and Warnings
Installer Error Messages (INSTERR)
• LDEV 1 disk space could also be an issue since the AIFs
create files on LDEV 1. Ensure that there was 60000
sectors of contiguous disk space reserved on LDEV 1.
• Take appropriate corrective measures, and run the
installer again.
• Contact the Response Center if further assistance is
required.
15 Message FINDJCW failure on STOREJCW. (INSTERR #15)
Cause The call to FINDJCW for getting the value of STOREJCW
returned an error status after restoring the FOS, SUBSYS
or POWERPATCH tapes or after creating the
POWERPATCH store tape.
Action • Ensure the JCW STOREJCW exists by issuing the
following command:
:SHOWJCW STOREJCW
• If STOREJCW has not been defined, try to set it by:
:SETJCW STOREJCW OK
• If either of the commands are successful, run the
installer again.
• Contact the Response Center if further assistance is
required.
16 Message The installer failed to checksum the SL.
(INSTERR #16)
Cause The checksum procedure failed to obtain checksums from
the SL.
Action • Enter LISTF SL.INSTALL.SYS to verify the copy of the
SL exists.
• Verify that the SEGMENTER can access the SL outside
of the installer:
:SEGMENTER
-SL SL.INSTALL.SYS
-LISTSL
Press CTRL Y to stop listing all the SL segments.
• Run the installer again.
• Contact the Response Center if further assistance is
required.
17 Message The installer failed to lock SL.PUB.SYS.
(INSTERR #17)
Cause The installer failed to execute the command FILE
SL.PUB.SYS;LOCK .