HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix H 347
Error Messages and Warnings
SETUP Error Messages (SETERR)
Action • Do a LISTEQ to determine the file equations that have
been set.
• Reset the files for which you no longer need file
equations. (If no file equations are needed, do a RESET
@.)
• Execute SETINIT.INSTALL.
• Contact the Response Center if further assistance is
required.
24 Message Unable to set file equation for the file
PEXL.INSTALL. SETUP
will terminate. Follow the instructions in your
installation manual
to continue. (SETERR #24)
Cause SETUP.INSTUTIL forces the file PEXL.INSTALL onto
LDEV 1 by setting a file equations prior to copying the file
from compact disk. However, SETUP.INSTUTIL failed
when attempting to set the file equation.
Action • Do a LISTEQ to determine the file equations that have
been set.
• Reset the files for which you no longer need file
equations. (If no file equations are needed, do a RESET
@.)
• Execute SETINIT.INSTALL.
• Contact the Response Center if further assistance is
required.
25 Message PURGEGROUP command failed when attempting to
purge the
group PUB. curr_acct. SETUP will terminate.
Follow the instructions
in your installation manual to continue. (SETERR
#25)
Cause SETUP.INSTUTIL uses the data file GRPNAMES.CD
vuuff .SYS to determine the accounting structure on the
compact disk set. SETUP. INSTUTIL must purge the
group PUB. curracct from the system domain prior to
binding to it on the CD.
Action • Ensure the group is not busy.
• Execute SETINIT.INSTALL.
• Contact the Response Center if further assistance is
required.
26 Message Unable to set file equation for OLDACCTS data
file.