HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

342 AppendixH
Error Messages and Warnings
SETUP Error Messages (SETERR)
• Contact the Response Center if further assistance is
required.
10 Message Unable to successfully bind to the group
group.account
. SETUP will terminate. Follow the instructions
in your installation
manual to continue. (SETERR #10)
Cause SETUP was unable to create a group that was listed in the
GRPNAMES data file.
Action • Type the following command to ensure that the group
does not exist.
:LISTGROUP GROUP.ACCOUNT
• Execute the SETINIT script to continue the
SETUP.INSTUTIL. If the group.account does not exist
and you are unable to create it, ensure that your
MANAGER.SYS,INSTALL (user.account,group) has
full MPE capabilities.
• Contact the Response Center if further assistance is
required.
11 Message The file filename could not be successfully
copied
to INSTALL.SYS. SETUP will terminate. Follow the
instructions in
your installation manual to continue. (SETERR
#11)
Cause SETUP copies all files from the CD vuuff .SYS group on
the compact disk to INSTALL.SYS group for use by
HPINSTAL. The file set consists of HPINSTAL and all of
its data files. This error is a result of the inability to copy
one of the HPINSTAL files from the CD vuuff .SYS group
into the INSTALL.SYS group.
Action • Perform the following command to determine if the file
exists and contains records.
:LISTF FILENAME. CD VUUFF .SYS,2
• Perform the following command to determine if the file
exists in INSTALL.SYS:
:LISTF FILENAME .INSTALL.SYS,2
• Ensure that the file is not busy.
• Then execute SETINIT.INSTALL.
• If SETUP still terminates abnormally, contact the
Response Center for further assistance.
12 Message The file filename could not be purged from the