HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix G 299
HP Stage/iX Reference
Using HP Stage/iX
• After staging area was created, but prior to applying (SET and boot) a staging area.
• After applying (SET and boot) from a staging area.
2. Identify the staging area condition at the time of the disaster.
• Staging area created but not booted.
• Staging area created and applied (SET and boot) from the staging area.
3. Perform a reinstall of your current operating system. Refer to the checklist from
Chapter 2 , “Task Checklists,” for directions on performing a reinstall task.
Hewlett-Packard recommends performing the reinstall from the backup made after the
staging area was created, but prior to applying (SET and boot) the staging area.
4. If you need to use the backup made after applying (SET and boot) from the staging area:
a. Perform the normal reinstall process.
b. You will not be able to RECOVER the staging area that the system was booted from. It
becomes the new Base. The reinstall from this type of backup is treated as an
implied COMMIT to the staging area.
c. RECOVER all other staging areas.