HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

240 AppendixD
Backdating Your System
Finishing Up
d. If you need to configure new DTCs on your system or if you need more information
on host-based network management, refer to Configuring Systems for Terminals,
Printers, and Other Serial Devices.
4. Display the Validate screen and validate the DTSLINK, NS links, and any other
configurations you have changed.
The specific method you use to view the Validate screen varies depending upon the
procedures you used to modify the configuration file. Refer to the Using the Node
Management Services (NM S) Utilities manual for more complete instructions.
NMMGR automatically invokes SYSGEN to cross validate the system and datacomm
configurations.
If inconsistencies occur during the validation process (such as two separate devices
configured to the same LDEV), do either of the following depending upon the type of
error:
• Resolve them using NMMGR (if related to networking).
• Exit NMMGR, NMMGR to revalidate DTSLINK.
5. Exit NMMGR.
Preparing for Final Reboot
Before performing the final reboot, stream jconfjob and verify all activities for manually
install products are complete.
To restart selected system functions:
1. If you purchased HP Resource Sharing and Information Access, install it now. Refer to
Appendix A , “Manually Installed Products.”
2. Stream JCONFJOB.
:STREAM JCONFJOB.NET.SYS
The JCONFJOB.NET.SYS stream is required for all systems. It includes information files
that describe the supported set of servers and services. These information files are used
to build a configuration file called DADCONF.NET.SYS. Wait until the above jobstream is
complete before continuing with the next step.
Set Passwords and Lockwords
Refer to “Setting Passwords and Lockwords” in Chapter 6 , “Finishing the Process.”
1. Set passwords for HP recommended accounts.
:ALTACCT acctname ;PASS= password
AUTOINST does not require the removal of passwords. However, if these accounts and
users do not have passwords, Hewlett-Packard recommends that you set them now.
BIND HPOFFICE HPSKTS JAVA SYS HPX11
CLL HPOPTMGT HPSPOOL RJE SYSLOG NETWARE