HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

236 AppendixD
Backdating Your System
Performing the Backdate
CM>SP
SP>RS
Enter Y to HARD BOOT the computer system.
b. For HP e3000 N-Class, A-Class
CTRL-B
GSP>RS
c. For all other systems:
CTRL-B
CM>RS
If the system does not respond, press the reset button, key switch, or on/off switch as
appropriate for your system.
Enter Y to confirm restarting the system.
5. Boot the system from the primary boot path.
a. Boot messages can vary, depending on the system model.
b. Enter Y to the Interact
with IPL? prompt, if it appears on your screen.
The system boots from disk. After some activity the ISL prompt displays.
6. Start the system.
ISL>START NORECOVERY
Restore FOS and SUBSYS
Refer to “Rerunning HPINSTAL” in Chapter 5 , “Modifying Your System,” for additional
information about these steps.
1. Remount the Factory Preload Tape (FPT).
2. Invoke HPINSTAL.
:HPINSTAL;INFO="RECOVERY"
The following is a sample system response:
MPE/iX HPINSTAL B.10.00 (c) Hewlett-Packard CO.
Mount the CSLT and put the tape/DDS drive online
The HP-supported software files will be restore.
**********Please stand by****************
The HP-supported software files are being restored.
The FPT is called the CSLT on the console screen. That is because the FPT is a type of
CSLT created at the factory.
3. Mount the FPT and put the tape drive online. This restores the STORE portion of the
FPT. If using DDS tape, you need to remove the tape and reinsert it now.
• The system then restores files, processes STORE files, creates the accounting
structure, and processes installation files.