HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix D 231
Backdating Your System
Performing the Backdate
configuration file that will be restored will require conversion using the
NMMGRVER.PUB.SYS utility after the installation.
Apply the CSLT
Refer to “Applying the Modification” in Chapter 5 , “Modifying Your System,” for additional
information about these steps.
To apply the CSLT:
1. From the console, mount the CSLT created from the factory SLT, FOS and SUBSYS of
the release to which you want to backdate. Refer to “Restore FOS and SUBSYS”.
Put the tape drive online.
Wait until the tape is mounted. A message displays on the system console verifying that
the tape mounted.
2. Shut down the system.
CTRL-A
=SHUTDOWN
3. Reset the system.
As appropriate to your system, do either Step a, b, or c:
a. For HP e3000 Series 99X:
CTRL-B
CM>SP
CM>RS
Enter Y to HARD BOOT the computer system.
b. For HP e3000 N-Class, A-Class
CTRL-B
GSP>RS
c. For all other systems:
CTRL-B
CM>RS
If the system does not respond, press the reset button, key switch, or on/off switch as
appropriate for your system.
Enter Y to confirm restarting the system.
4. Boot the system from the alternate boot path, where the CSLT is mounted.
a. Boot messages can vary, depending on the system model.
b. Enter Y to the Interact
with IPL? prompt, if it appears on your screen.
The system boots from the alternate source (tape). After some tape activity, the ISL
prompt displays.
5. Update with the CSLT created from your Factory SLT.