HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix D 227
Backdating Your System
Performing the Backdate
If the system does not respond, press the reset button, key switch, or on/off switch as
appropriate for your system.
Enter Y to confirm restarting the system.
5. Boot the system from the primary boot path.
1. Boot messages can vary, depending on the system model.
2. Enter Y to the Interact
with IPL? prompt, if it appears on your screen.
The system boots from disk. After some activity the ISL prompt displays.
6. Start the system.
ISL>START NORECOVERY
Check Volumes
Refer to “Checking Volumes” in Chapter 5 , “Modifying Your System,” for additional
information about these steps. For more information on VOLUTIL commands, refer to the
Volume Management Reference Manual.
If necessary, use the VOLUTIL utility to add system volumes, including the system domain
(MPEXL_SYSTEM_VOLUME_SET) disk drives (except LDEV1).
1. Log on, start the spooler, and streams device.
:HELLO MANAGER.SYS,INSTALL;HIPRI
:LIMIT 1,1
:SPOOLER LP;OPENQ
:STREAMS streams_device
where streams_device is the device number. A common streams_device value is 10.
An LP device must be configured in SYSGEN. Already spooled and streamed messages
might display.
Ignore the group
out of connect time warning, if it displays.
2. Enter a DSTAT command to verify a status of master for the disk drives. All system
volumes showing a status of LONER must be added using the VOLUTIL utility.
3. Add system volumes. Use scratchvol and newvol commands.
4. Check all volumes to confirm they are configured correctly. Use the DSTAT command.
:DSTAT ALL
Restore FOS and SUBSYS
Refer to “Creating the CSLT Using AUTOINST” in Chapter 5 , “Modifying Your System,”
for additional information about these steps.
AUTOINST sets up the necessary environment, restores files, creates the accounting
structure for the installation, and creates a CSLT.
1. Change to group install.