HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

218 AppendixD
Backdating Your System
Performing the Backdate
Performing the Backdate
In this section you backdate your system. The procedures vary depending upon the
backdate method you are using. Refer to the appropriate section.
• Method 1: Using a CSLT
• Method 2: Using a Factory SLT
• Method 3: Using an FPT
Method 1: Using a CSLT
To backdate using a CSLT perform the steps in the following sections:
• Apply the CSLT
• Restore Account Information
• Restore FOS and SUBSYS
Apply the CSLT
Refer to “Applying the Modification” in Chapter 5 , “Modifying Your System,” for additional
information about these steps.
1. From the console, mount the CSLT created during the last full backup of the release to
which you want to backdate.
Put the tape drive online.
Wait until the tape is mounted. A message displays on the system console verifying that
the tape mounted.
2. Shut down the system.
CTRL-A
=SHUTDOWN
3. Reset the system.
As appropriate to your system, do either Step a or Step b:
a. For HP e3000 Series 99X:
CTRL-B
CM>SP
SP>RS
Enter Y to HARD BOOT the computer system.
b. For HP e3000 N-Class, A-Class
CTRL-B
GSP>RS
c. For all other systems: