HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Chapter 6 161
Finishing the Process
6.8 Restarting Selected System Functions
a. Type:
:cstm
cstm> ru termdsm
b. At the termdsm prompt, Type R:
Connect DIag DTc DUmp EEprom Help Reset Status Trace EXit ?R
c. For each DTC, Type:
(reset)
Ldev#
POrt#,#,#
SNp #,# (X.25 card in DTC)
VC #,#,#,
Slc #,# (multiplexer card in DTC)
DTc #
(carriage return to exit) ?DTCnn
where nn is the DTC number.
5. Start Internet Services.
If you have any Internet Services configured (telnet, ftp, etc.), stream the Internet
Super Daemon job.
:STREAM JINETD.NET.SYS
For more information, refer to the Configuring and Managing MPE/iX Internet
Services manual.
6. Turn HP Predictive Support back on.
If you are using the HP Predictive Support software as part of your Hewlett-Packard
hardware support contract, ensure that an HP Predictive Support run completes
successfully.
a. Issue the HP Predictive Support command:
:RUN PSCONFIG.PRED.SYS
This run of HP Predictive Support may include a transfer of files to the
Hewlett-Packard Response Center. If a transfer is needed,
be sure it completes
because the system update overwrites the information in the file
PSDCFILE.PRED.SYS.
b. Select item 4, Configuration, from the Main menu.
c. Select item 5, Schedule, from the Configuration Options menu.
d. Select item 1, Schedule (ON/OFF), from the Schedule menu.
e. Set the preference, at the prompt, type ON:
Type schedule preference (on/off) or // to cancel: __
f. Exit the program, at the prompt, type EXIT: