HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Chapter 5 119

Modifying Your System

5.5 Conﬁguring the System

CTRL-B

CM>SP

SP>RS

Enter Y to HARD BOOT the computer system.

Do not respond to the question:

Press any key within 10 seconds to cancel boot with this configuration.

There are 5 to 10 minutes of system activity, then the Processor Dependent Code

(PDC) screen displays.

b. Eassnter the following commands to reset the system:

CTRL-B

CM>RS

If the system does not respond to the CTRL-B entry within ten seconds, press the

reset button, key switch, or on/off switch as appropriate for your system. The system

will halt, and then restart automatically.

Enter Y to conﬁrm restarting the system.

7. Boot the system from the primary boot path.

a. Boot messages can vary, depending on the system model.

• If you have AUTOBOOT enabled, and you do not override AUTOBOOT, the system

boots from the primary boot path automatically.

• If your system prompts to enter the boot path, enter the primary boot path.

• For Model 9x8LX, 9x8RX, 9x9KS, N-Class, or A-Class systems, type BO at the

PDC screen to boot from the primary boot path.

• If your system prompts, Boot from primary

boot path?, enter Y.

b. Enter Y to the Interact with IPL? prompt, if it appears on your screen.

The system boots from disk. After some activity the ISL prompt displays.

8. Start the system.

ISL>START NORECOVERY

• Conﬁguring the System completed. Go to the next section on your

checklist.