HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Chapter 5 117
Modifying Your System
5.4 Starting the System
bank 13: 64MB
RUN COMPLETED.
• Listing the System Configuration completed. Go to the next section on your
checklist.
5.4 Starting the System
When the update is complete, autoboot begins. Perform the following steps to ensure the
system is up and running.
To start the system:
1. Start the system.
ISL>START NORECOVERY NOSYSSTART
If you are Installing a New System, add group= configname to the command string.
ISL>START NORECOVERY NOSYSSTART GROUP=configname
where configname is the configuration group for your system. Refer to Appendix B ,
“Configuration Tables,” for a list of configuration groups.
2. Confirm the date and time.
You are prompted to confirm the date and time. If the date and time displayed are not
correct, enter N, and enter the correct date and time or you may use the MPE/iX
SETCLOCK command. If you do not respond within 15 seconds, the system continues.
MPE/iX launch facility
Initialize_genesis - Version: <<870204.1552>>
TUE, APR 19, 1994, 10:20:03 AM (y/n)? Y/N
[TMUX_DAM] n n n n
Initialize genesis completed.
The system displays start-up and initialization messages for 5 to 6 minutes. For
example:
Initialize genesis completed.
Create Console Messages completed.
Initialize memory manager completed.
Initialize resident kernel completed.
. . .
Protection of system files has been completed.
. . .
SESSION Scheduling Initialized
Initiate Operator Logon
JOB Scheduling Initialized
Successfully launched diagnostic monitor process.
During the start-up process, the system makes several configuration checks and may
display warning messages. This is normal for system start-up, and will not affect
system operation.