HP e3000 Fibre Channel Mass Storage Adapters Service and User Manual (32650-90910)

Chapter 4
Troubleshooting
HP Support Tools Manager (STM) under MPE/iX
25
HP Support Tools Manager (STM) under MPE/iX
This section describes how to use STM to gather information about the Fibre Channel adapters and diagnose
problems. If you are not familiar with STM, check out the new STM MPE/iX Quick Reference Guide at the
following URL: http://docs.hp.com/hpux/diag. Then select MPE/iX Diagnostics.
NOTE Use the CSTM command to start STM in Command Line Mode.
PUB:CSTM
CSTM B8343AA.75.00 Version created MON, JAN 28, 2002 12:02 PM
Running Command File (/usr/sbin/stm/ui/config/.stmrc).
This operation may take approximately one minute.
-- Information --
MPE/iX Support Tools Manager --Product Number B8343AA, Version A.75.00
(C) Copyright Hewlett Packard Co. 1995-2002 All Rights Reserved
Use of this program is subject to the licensing restrictions described in "Help-->On Version". HP shall
not be liable for any damages resulting from misuse or unauthorized use of this program.
Information tool provides information about a Fibre Channel adapter without resetting the adapter.
The following is an example information log for a e3000/A500-200-14 system: (user input in BOLD)
cstm>MAP
Dev Last Last Op
Num Path Product Active Tool Status
=== ================= ====================== =========== =======
1 system system ()
2 0 PCI Bus Adapter (582)
3 0/0 PCI Bus Adapter (782)
4 0/0/1/0 PCI SCSI Interface (10000
5 0/0/1/0.16.0 Unknown ()
6 0/0/1/0.17.0 Unknown ()
7 0/0/1/1 PCI SCSI Interface (10000
8 0/0/1/1.15.0 SCSI Disk (SEAGATEST39204
9 0/0/2/0 PCI SCSI Interface (10000
10 0/0/2/0.6.0 Unknown ()
11 0/0/2/1 PCI SCSI Interface (10000
12 0/0/2/1.6.0 Unknown ()
13 0/0/2/1.15.0 SCSI Disk (SEAGATEST39204