HP Data Entry and Forms Management System (VPLUS) Reference Manual (32209-90024)

194 Chapter5
Reformatting Specifications
Using REFSPEC
REFSPEC Function Keys
A set of seven function keys, similar to those used for forms design, are used to control
execution of REFSPEC. These keys are described in Table 5-1.
NOTE The function keys used by REFSPEC should not be confused with the
function keys defined for ENTRY (see Figure 2-2). Although the two groups of
keys are physically the same programmable keys, their functions differ
significantly.
Table 5-1. Key Definitions
Key Key Action
PREV FORMAT
f1
Go to previous Input Forms Menu (skipping any intervening menus).
NEXT FORMAT
f2
Go to next Input Forms Menu (skipping any intervening menus).
f3 Not defined.
REFRESH
f4
Redisplay current menu in its initial state before anyspecifications were entered,
or existing specifications were modified.
PREV
f5
Position to Previous Menu screen in sequence of menus.
NEXT
f6
Position to Next Menu screen in sequence of menus.
MAIN/ RESUME
f7
Request Main Menu or, if Main Menu displayed, return to menu displayed when
Main was requested.
EXIT
f8
Terminate REFSPEC and return to MPE control.