Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Configuring Serial Devices (for PC-Based Management)

Modify the Network Management Configuration File

Chapter 6

Step 5: Select DTC Type

The DTC Configuration Selection screen (Figur e6-4) is displayed when you press the

[Go To DTC]

key at the Host Configuration screen. Here you specify the type of DTC to

configure. You only need to configure DTCs with nailed ports that will be accessed by

this HP e3000 computer.

Figure 6-4 DTC Configuration Selection Screen

1. Select the DTC type by pressing one of these function keys:

[DTC16iX]

[DTC16MX/RX]

[DTC16]

[DTC48]

, or

[DTC72MX]

NMMGR will take you to the corresponding configuration screen for the specified DTC

type.

NOTE Automatic DTC configuration is not available for PC-based environments. If you answer

Y to the question “Automatically add/configure a new DTC (Y/N)?” on this screen,

you will see an error message.