Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Configuring Serial Devices (for PC-Based Management)

Copy the Sample File

Chapter 6

Copy the Sample File

Network information is stored in a configuration file called NMCONFIG.PUB.SYS. If you do

not already have a NMCONFIG.PUB.SYS file, create a copy of NMCONFIG.PUB.SYS from the

sample configuration file supplied on the HP e3000, NMSAMP1.PUB.SYS.

To copy NMSAMP1.PUB.SYS into NMCONFIG.PUB.SYS, enter these commands at the

MPE/iX prompt (:):

HELLO MANAGER.SYS,PUB

FILE CONFIG=NMCONFIG.PUB.SYS;DEV=1

FCOPY FROM=NMSAMP1.PUB.SYS;TO=*CONFIG;NEW

NOTE “DEV=1” must be specified in the FILE equation to specify that the NMCONFIG.PUB.SYS

file is to be stored to system disk 1.

CAUTION If ANY other configuration file is copied to NMCONFIG.PUB.SYS or NMCONFIX.PUB.SYS

then dynamic configuration will be disabled until a DTS shutdown and restart is done or

the system is rebooted. This includes other files from the same system or files copied

from other systems.