Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Configuring Serial Devices (for Host-Based Management)
Modify the Network Management Configuration File
Chapter 5
70
Modify the Network Management Configuration File
Use NMMGR to enter asynchronous device configuration information into the network
management configuration file (NMCONFIG.PUB.SYS). A step-by-step procedure for
updating the host’s network management configuration file follows.
NOTE Before modifying the NMCONFIG.PUB.SYS file, make a backup copy of it. If the
modifications made to the configuration file are successful, purge the backup copy.
Step 1: Begin the Configuration Process
Run the NMMGR program. Node manager (NM) and network administrator (NA)
capabilities are required to run this program. To run NMMGR, enter the following
command at the MPE prompt and then press the
[Return]
key.
NMMGR.PUB.SYS
NOTE You must be logged on to the SYS account to run NMMGR.